Warm reminder
It takes about 3 hours to fully charge the product. You need to turn ON the power first and then charge the product.
When starting a car, you need to turn the switch to OFF before starting the car.
Our store offers car power supplies with peak capacities of 400A and 600A. The product with a peak capacity of 400A has a power amplifier of 40C and can start gasoline vehicles with an engine displacement of 3.0 or less. The amplification at a peak of 600A is 60C. It can start gasoline vehicles with a displacement of less than 6.0 and diesel vehicles with a displacement of less than 3.0. (Except for vehicles with aging engines)
If the product is not used for a long time, it is recommended to charge it once every three months.
6: The product needs to be placed at room temperature, which is beneficial to its service life.
Special Precautions for Using Power banks
When starting the car, make sure the blue plug is inserted tightly and in place; otherwise, it will affect the effect.
When starting the car, it is best for the blue battery level indicator light to be above 60%, which can extend the service life of the product.
3. If the car fails to start, do not force it to continue. Check whether the battery clamp is properly fastened and whether the original battery head is rusty or dirty. Continue to start after cleaning.
4. During the starting process, if the vehicle fails to start (1-2 times), do not force it to start again. Instead, further check for any other faults; otherwise, it may cause the fuse to burn out and the starting power supply to be damaged.
5: When starting the car and using the air pump and other on-board electrical appliances through the clamp port, the switch needs to be turned to OFF.
Our store offers car power supplies of different models, 400A and 600A. If your car exceeds the A rating of the product, the power supply will automatically cut off the power during the car start-up process for protection. Just plug in the charger and reactivate it, and it can be used normally.
7: When the car is running out of power or has no power at all, simply clip the car power clips directly onto the positive and negative terminals of the car to start it. If the car is powered on, remove the positive terminal, clip the clips onto the ground, and clip the negative terminal onto the negative terminal to start it.
When starting the car for the first time, it is necessary to completely discharge the battery inside the product, then plug in the charger to charge it, and then start the car again.
